We have installed on Kiwi Syslog Server in a workstation in the hopes of displaying syslog messages from our Cisco Catalyst 3560G switch. We entered the following commands into the 3560G switch to turn logging on and direct those messages to the Kiwi Syslog server. The Cisco IOS commands we entered were as follows:
Enable mode
config t
logging <IP Address of the workstation that Kiwi syslog server is installed on>
logging trap 7
End
Wr mem
Everything appears to be set up properly but there are no syslog messages displayed in the Kiwi Syslog Server. We are trying to capture all messages from the switch because we are trying to troubleshoot an issue with it. Does anyone have an idea as to why we aren't getting any messages in Syslog Server.
Thanks,
Ben